08 ZN Vrap Greif
Replica of an Avar belt stud with the motif of a gryphon after a Merovingian model from Vrap / Albania. Bronze, silver-plated or 925 silver. 3.5 x 2.5 cm.
08 ZN AVGH
Replica of an Avar belt hanger after a model from the Merovingian period, dating back to the 8th century. Bronze, silver-plated or 925 silver. 6.6 x 1.5 cm
08 ZN VR-KL
Faithful replica of a small Avar belt stud of the Merovingian period after an original finding from Vrap / Albania. Bronze, silver-plated or 925 silver. 1.7 x 1.1 cm.
08 ZN VR-Palm
Avar belt fitting with palmette motif after a model from Vrap in Albania, dating back to the 7th century. Bronze, silver-plated or 925 silver. 2.5 x 1.8 cm.
09 End Vrap DB
Replica of an open-work Avar belt end of the Merovingian period made after an original find from Vrap. Bronze, silver-plated or 925 silver. 9.5 x 2.7 cm.
09 End Vrap KL
Replica of an Avar strap end for 1.5 cm wide belts after an early Medieval model dating back to the 8th century. Bronze, silver-plated or 925 silver. 4.8 x 1.4 cm.
Dealers for museum supplies, medieval and Viking re-enactment or LARP are cordially invited to register as retailer for wholesale in Pera Peri's medieval shop. We guarantee the best quality at good prices with short delivery times!
Replica of an Avar belt buckle with hinge.
This replica of a Merovingian belt buckle with the depiction of palmettes was made after an Avar model dating to the 7th - 8th century.
Belt sets were very common in the early Middle Ages during the Merovingian period among the Avar horsemen in the Kaparten Basin and were an important expression of rank, status and clan within Avar society. Belt fittings are therefore found very frequently in Avar finds from this period.
The Avar buckle measures 4.5 x 2.6 cm.
The belt buckle is suitable for belts with a width of 1.5 cm.
The Avar belt buckle is made of high-quality bronze and is also available in genuine silver-plated.
Fastening: There are four pins on the back of the Avar belt buckle. To fasten the decorative rivets, simply insert them through the corresponding holes in the leather. It is best to use pliers to bend the tips inwards a little. If you then tap the pins flat with a hammer, the tip will sink into the leather and the Avar buckle will be stable and flat on the belt.